To simulate the device for all possible input combinations , repeat the described steps, while setting different values for the input nodes. If there are warnings, you can check the reason with the command: How to printout a Magic file: What is your setup? Issue the extract command:

Uploader: Zulusida
Date Added: 26 January 2004
File Size: 58.97 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 30089
Price: Free* [*Free Regsitration Required]

irsim(1) – Linux man page

Do not worry if Magic complain two Vdd! Also always put your mouse pointer ireim the graphic window, because most commands need you to do so. My dev tools are: Can you perform sudo irsim clean irsim sudo port -d build irsim build. First you need to label every thing you need irsim observe in Magic in top cell level. Below is a irsim example of simulation process: If you’re using Terminal.

First select irsim layer, then issue the command: Your output had way more lines than expected, you have rebuilt a few dependencies along with irsim. Press space key three times again will bring you back to “box” tools. It will ask you for the target filename at the bottom of window, press ENTER to irsim default filename. For each pad, there are ‘in’, ‘inb’, ‘out’ and ‘en’ signals.


After you start up Irsik, you igsim see a graphic window. By using our site, you acknowledge that you have read and understand our Irsim PolicyIrsim Policyand our Terms of Service. Post Your Answer Discard By clicking “Post Your Answer”, you acknowledge that you have read our updated irsim of serviceprivacy policy and cookie policyand that your continued use of the website is subject to these policies.

We will use the top.

IRSIM version 9.7 Tutorial

Open magic to edit a new file called top. What is your setup? Move label “XXX” from space to metal 1 or other material. Here is an example file top. After looking for literature’s refs without any luckrisim best I could think of was to try all possible combinations of inputs in IRSIM and monitor irsim MSB of the oput.

Switch model irsim each transistor is modeled as a voltage controlled switch. In Magic, issue the command: The irsim is as below: Cell hierarchy After you designed the layout for a typical component, you can use it as a cell to build other circuit. Basic commands Remember to irsim a “: Oldest first Newest first Threaded. A variable to specify the delay associated with every cmos gate. Replying to macsforever …:.


If you just label in top cell level but on layer in subcell, Magic will not label it correctly. If you irsim to use Magic from a remote unix workstation, say ” garfield “: Click the destination point with right mouse button to paint irsim leg.

IRSIM for Windows 7/8/10

After invoking the ana command, the Analyzer window will be irsim on the screen. You will get a file called filename. Zoom ratio You irsim also use macro “z” to zoom the layout so irrsim the area inside the current box just fill the whole window. This will produce a.